Setting Ignition Timing – KA24DE 240sx

Now that you understand the place the timing marks are on the crank pulley in your 240sx KA24DE, comply with these steps to set correct ignition timing.

Engine heat – unplug tps sensor

loosen the two 10mm bolts on the distributor, loosen, not take away.

begin the engine along with your timing gentle pointing on the crank pulley.

rotate your distributor to twenty which is the very proper timing mark when wanting down at it.

If you can’t get it fairly proper, it’s doable you’re 1 tooth off in your distributor and must reinstall it.

Plug again in your TPS and tighten the two distributor bolts and your set. In case your idle is simply too excessive, or too low, regulate it through idle valve i